Detailed installation method of ball bearing deep groove ball bearing

June 27, 2022

Bearings without cages are installed; usually more than half of the steel balls are loaded first; or steel balls are loaded in the number of 186. according to the filling angle; other steel balls are to be loaded from the filling gaps. Fall out; the radius of curvature of the inner and outer gaps of the bearing is equal to or greater than the radius of curvature of the sodium ball; but the minimum spacing between the inner and outer notches is smaller than the diameter of the steel ball. The same; the ball is loaded with the ball; the steel ball is not easy to enter. Among the bearing channels.
The ball is raised and rushed to each side with a viewpoint; it is inclined; it is easy to be pressed to open the gap. There is a ball socket in the rising and rushing; it can be put into the steel ball; after the rushing; the steel ball enters the raceway. When loading the bhttps://www.bosch-bearing.com/all; The inner and outer gaps must be aligned; the inclined surface of the punch is used under the press of the press. The internal and external factors are elastically deformed together to expand; the gap size is increased; the steel ball can be properly connected to the bearing. If the hydraulic machine is used to load the ball; the steel ball can be opened when the gap is opened. Installed in succession. If using a crankshaft press and other equipment to load the ball; 5rJ after each steel ball; should pull or change the ferrule to make the steel ball out of the gap; in order to reload the next steel ball; until the steel ball is full Stop. When using the ball to fill the ball; prevent the use of large tonnage crankshaft or core press; avoid the formation of a safety accident.
Select the type 5 cage with the ball-notched deep groove ball bearing; the number of steel balls is even. In the installation; first install half of the steel ball into the bearing; then enter the 5-type cage from the bearing end side; Separate the ball. Then apply the upswing from the ball gap; insert the other half of the ball into the other side of the s-type cage. Because the ball and the cage are mutually disturbed; the gap between the inside and the outside is difficult to The ball socket of the cage is aligned; therefore, the ball loading process is difficult; usually it is necessary to rotate the bearing for dozens of reasons to push the orientation of the three.

Recommend to friends comments close window

Bearing related knowledge

NSK bearing in the three strong points of nylon support frame analysis of the early damage of the imported bearings, the common code can not express the bearing code commonly used bearing ring axial fastening method to analyze the four ways to open the rolling bearing

Sebelumnya

Hubungi Kami

Author:

Mr. Star Wang

E-mel:

info@bosch-bearing.com

Phone/WhatsApp:

+8613563512935

Produk popular

Berita Syarikat

Galas paling popular di disatukan

October 17, 2022